Reinforcement Lapping Length for Beam Column and Slab




Hello friends, In this article today I will discuss you about Reinforcement Lapping Length for Beam Column and Slab, Because many lecture can teach you different formulas for lapping length in beam , column and slab etc.

What is lapping length:

lapping length is also called overlapping length, and lapping length we can define when the steel in bar is not sufficient for the design length which we required, so for that we lap the other steel to complete the design length , so there two steel should be overlapping on each other that is called lapping or overlapping length.

Lapping length can transfer the load from on e member to other, and the reinforcement bar need to be firmly bind at both ends.

also read :Difference between Development Length and Lapping Length



Lapping Length formulas for Beam column and slab

Remember that Column is Compression member and Beam is Tension member

Lapping Length for Compression member (Column ) =   48 D         here D is the Diameter of steel which we used in the Column ( Longitudinal bars )

Example : If I use 12mm dia of steel in the beam so what will be the lapping length in the beam.

also read: Important points for Calculation of steel Reinforcement

Solution:

Lapping length for Column  = 48 D   = 48 (12) = 576 mm

 

Lapping Length for beam and slab = 60D             Here D is the dia of steel which we used in the slab or beam.



 

For more detail watch the given video

 

written by : engr sami ullah stanikzai

 

Add a Comment

Your email address will not be published. Required fields are marked *

error: Content is protected !!