Design of beam




Hello Friends, In this article I did design personally for a small house which wall load was 8KN/m so this is my personal design and you can also use this design up to 8KN per running meter. lets get start.




In a beam of up to 5 meters length, secondary spans of up to 4 meters, wall loads of up to 8 kN per running meter, I can use steel as below.

Design of Beam 

  1. Use 2 No’s of steel bars in Top section of beam ( Top steel ) which Diameter should be 12 mm.
  2. Crank bars should be also use in this beam which diameter should be also 12mm and crank bars should be bend with 45° at a distance of L/4 at both ends of a simply supported beam.
  3. Use 3 No’s of steel which diameter is 12mm.



I did this design personally.

read more: Why are chairs used in reinforcement?

read more: Difference between Bridge and Flyover?

Written by: Engr Sami Ullah Stanikzai



Add a Comment

Your email address will not be published. Required fields are marked *

error: Content is protected !!